Jump to content

Gemmy Ferris wheel belt


Jerry Wagemann

Recommended Posts

I tightened the belt on ours last year, but do not have a picture right now, will be setting up later this month.

 

Basically I took a short bolt, put a brass sleeve on it a bolt, put on a nut, leaving space for sleeve to spin, drill hole in plastic case near belt (sleeve goes on outside of belt, against it to keep it tight, then bolted bolt from other side.  so far so good, ran for 4 weeks last year, also used large washers against plastic case so plastic would not break.

 

hope this helps,   also looking for a motor as a spare if anyone knows a good place to get them.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...