Search the Community
Showing results for tags 'wreath'.
Found 4 results
I am having some issues with a 60in light up wreath. 7/8 of the thing lights up but half of 1 section is completely out. I have tried replacing bulbs, used the Christmas light tester tool but I am stuck. Today I found what I think is where it is losing power or transfer of power to the next bulb Anybody have any idea what type of bum set up this is? Or how to fix it? I am pretty sure this is where the lights stop from bulb to bulb. I have never seen bulbs like this before and have tried everything except splicing the wires again. How can I fix this so I can use this wreath again?The bulb before this has the same housing and works fine.
Wreath I programmed using a Siemens S7-200. I cut a string of lights into 10 sections of 24 volts each to run off the DC power supply & the PLC's DC outputs. The outputs are controlled by a counter that counts up to 87 based on a timer set at 0.42 second pulses. Thsi entire project was completed in less than 2 days after I thought it up, although I have tweaked the program since the video was taken.
I hope this is in the right section. I have searched all over the internet for a way to make a wreath that appears to be glowing. Perhaps someone could help point me in the right direction. I am talking about a wreath that is made apparently of the stiff ribbon and the whole thing seems to glow when it is lit up. Unlike most wreaths you do not see the individual bulbs on the inside of the wreath. I hope that is not too confusing of an explanation. I am wanting to make three of these this year for our display. Thanks in advance if anyone can help me out with this.